The stress analysis and optimum of the cryogenic insulated-cylinders under the inertia force based on ANSYS 使用ANSYS对惯性力作用下的低温绝热气瓶进行应力分析与优化
The water lubrication performance of elastic-metal-plastic ( EMP) thrust bearings was affected by liquid inertia force and interfacial slip. 通过数值计算,考察了流体惯性对圆柱轴承润滑性能和承载能力的影响。
Withstand Seismic Inertia Force When the Dam Impermeable Geomembrane Study the Stability of the Structure 承受地震惯性力时坝体土工膜防渗结构的稳定研究
With the development of high-speed press on speeding up and lightweighting, it causes the augmentation of inertia force and component's flexibility. 随着高速压力机向高速化及轻量化方向发展,导致了惯性力的增大及部件柔度的增大。
How to design the control mechanic of insect-like flapping wing air vehicle to increase the symmetrical and eliminate the influence of inertia force was discussed at last. 如果翅膀拍动对称的同时转动对称,就可认为翅膀的扑动是严格对称的,此时翅膀惯性力可以忽略。
Full balance of inertia force of mechanism 机构惯性力的完全平衡
Air flow is offset under actions of the blade-lattice surfaces after entering the blade-lattice air passages, and dust in air can be collected in the grooves under actions of inertia force. 气流进入叶栅槽道后,在叶栅型面作用下,气流发生偏移,空气中的沙尘在贯性力作用下被收集在型槽中。
The calculation of the inertia force of motocrane under swinging condition 汽车起重机在摇摆工况下的惯性力计算
Under the condition of the first inertia force's absolute balance in the compressor, the form of the second inertia force was analysed, which has never been balanced in the machine. 在一阶惯性力机器内完全平衡的情形下,对二阶惯性力因目前无法在机器内平衡,分析其形成的机理。
This paper takes a living quarter for example to introduce in brief the theory of towing inertia force, calculation formulas, load combination, FEM simulation and structural strength check. 文章以某生活模块为例,对海上运输过程中产生的拖航惯性力的生成理论、计算公式、荷载组合、有限元程序模拟、结构强度校核等进行简要介绍。
Effects of Liquid Inertia Force and Interfacial Slip on Water Lubrication Performance of Elastic-Metal-Plastic Thrust Bearings 惯性及滑移对EMP推力轴承的影响研究
Generalized variational principles in theory of elasticity A New Method to Apply Inertia Force of Rigid Body in Dynamic-static Method 理论力学动静法中刚体惯性力的另种加法
Dynamic and kinematic analysis of cutting mechanism of small harvester and balance of inertia force 小型收割机切割机构运动学和动力学分析及惯性力平衡
The first order reciprocating inertia force can be reduced by means of adopting a single balancing shaft and designing the crankshaft balance weight right. 采用单平衡轴和对曲轴配重合理设计的方法降低单缸摩托车发动机的一阶往复惯性力。
With the quotation of the concept of the constant scalar potential, the author explained the cause of the acceleration in gravity field, reckoned some formulas, unified the gravity and the inertia force, then compared the theory with the general relativity. 引入了常数标量势的概念,揭示了引力场中加速度的成因,导出了若干公式,统一了引力和惯性力,并将理论与广义相对论的结果作了比较。
Integrated Balance of Inertia Force and Moment in Plane Mechanism 平面机构惯性力和惯性力矩的综合平衡
The effects of eccentric mass, damping, inertia force and gravity on the vibration amplitude were analyzed. 在此基础上,分析了质量偏心、阻尼、惯性力和重力对振幅的影响。
The quadratic reciprocating inertia force balancing mechanism is designed to obtain low vibration and noise. 自行设计了二阶往复惯性力平衡机构,在提高转速的情况下,实现了整机的低振动和低噪声以及平稳的运转性。
The wind velocity of first order instability is obtained from the dynamic equilibrium relationship between aerodynamic force with dead weight and inertia force of membrane. 根据气动力与薄膜自重和惯性力之间的动力平衡关系获得了薄膜一阶失稳时的临界风速。
The test result shows that the vibration caused by the unbalanced reciprocating inertia force is greatly reduced. 样机测试结果表明往复惯性力不平衡引起的振动显著降低。
Based on the principle of: Inertia Force Method "and the analysis of"? 根椐“惯性力法”原理,利用“卡岗”的分析方法,解得地震主动土压力沿墙高非线性分布的计算公式和合力以及合力作用位置的计算公式。
Counterbalance of the inertia force and vibration absorption of the reciprocating cutter 往复式切割器惯性力的平衡和减振
First, the distribution of Coriolis inertia force is formulated in the axisymmetric solid with gyroscopic effect. 首先,推导了轴对称体中哥氏惯性力的分布公式。
Calculation of the inertia force and inertia force moment on the drive ring plate and tumbler eccentric axis shows that the inertia force and inertia force moment of the reducer's driving mechanism are fully equilibrant. 传动环板及转臂偏心轴惯性力和惯性力矩的计算结果表明,这种减速器传动机构的惯性力和惯性力矩理论上是完全平衡的。
For the purpose of reducing vibration and noise, it uses biaxial linkage equilibrium to test equipment inertia force. 使用双轴联动方式平衡测试设备惯性力,以达到降低振动和噪声的目的。
Before the author put forward inertia force, all active contours evolved in non-inertial system. 在作者提出惯性力场之前,所有活动轮廓模型都是在非惯性系中演化的。
Based on presented controlling velocity method, this thesis investigates wheel-rail rolling contact under inertia force. 在考虑惯性力的条件下,利用本文所提出的速度控制方法,模拟了轮轨滚动接触行为。
According to Newton-Euler dynamics iterative algorithm to calculate inertia force and inertia moment of micro-robot, achieved inertia compensation. 根据牛顿-欧拉迭代的动力学算法计算微机器人自身惯性对宏-微机器人运动的影响,补偿在机器人运动过程中微机器人产生的惯性力。
This thesis discusses the standard maneuver in deepwater, and divides hydrodynamic force into inertia force and viscous force. 主要研究的是深水条件下的常规操纵,将水动力分为惯性力和黏性力两类。
Besides, the effect of piston reciprocating inertia force on the dynamical response of the VCC mechanism is analyzed. 同时还分析了活塞往复惯性力对VCC机构动态响应的影响。